溶氧感測器-序列埠監控視窗

[admin]

2.溶氧感測器 序列埠監控視窗.pdf

#define DO_PIN 36

#define VREF 5000    //VREF (mv)
#define ADC_RES 4096 //ADC Resolution

//Single-point calibration Mode=0
//Two-point calibration Mode=1
#define TWO_POINT_CALIBRATION 0

#define READ_TEMP (25) //Current water temperature ℃, Or temperature sensor function

//Single point calibration needs to be filled CAL1_V and CAL1_T
#define CAL1_V (1600) //mv
#define CAL1_T (25)   //℃
//Two-point calibration needs to be filled CAL2_V and CAL2_T
//CAL1 High temperature point, CAL2 Low temperature point
#define CAL2_V (1300) //mv
#define CAL2_T (15)   //℃

const uint16_t DO_Table[41] = {
    14460, 14220, 13820, 13440, 13090, 12740, 12420, 12110, 11810, 11530,
    11260, 11010, 10770, 10530, 10300, 10080, 9860, 9660, 9460, 9270,
    9080, 8900, 8730, 8570, 8410, 8250, 8110, 7960, 7820, 7690,
    7560, 7430, 7300, 7180, 7070, 6950, 6840, 6730, 6630, 6530, 6410};

uint8_t Temperaturet;
uint16_t ADC_Raw;
uint16_t ADC_Voltage;
uint16_t DO;

int16_t readDO(uint32_t voltage_mv, uint8_t temperature_c)
{
#if TWO_POINT_CALIBRATION == 0
  uint16_t V_saturation = (uint32_t)CAL1_V + (uint32_t)35 * temperature_c - (uint32_t)CAL1_T * 35;
  return (voltage_mv * DO_Table[temperature_c] / V_saturation);
#else
  uint16_t V_saturation = (int16_t)((int8_t)temperature_c - CAL2_T) * ((uint16_t)CAL1_V - CAL2_V) / ((uint8_t)CAL1_T - CAL2_T) + CAL2_V;
  return (voltage_mv * DO_Table[temperature_c] / V_saturation);
#endif
}
double DOSensor;

void setup()
{
  Serial.begin(115200);
}

void loop()
{
  Temperaturet = (uint8_t)READ_TEMP;
  ADC_Raw = analogRead(DO_PIN);
  ADC_Voltage = uint32_t(VREF) * ADC_Raw / ADC_RES;
  DOSensor = ((double)(readDO(ADC_Voltage, Temperaturet))/1000);
  Serial.print("Temperature:\t" + String(Temperaturet) + "\t");
  Serial.print("ADC RAW:\t" + String(ADC_Raw) + "\t");
  Serial.print("ADC Voltage:\t" + String(ADC_Voltage) + "\t");
  Serial.println("DO:\t" + String(readDO(ADC_Voltage, Temperaturet)) + "\t");
  Serial.print("目前溶氧：");
  Serial.println( String(DOSensor) + " mg/L");  

  delay(1000);
}```